Характеристики

                     Garden Watering Timer Automatic Electronic Water Timer Home Garden Irrigation Timer Controller System autoplay irrigator

Package:

1 pc / pack

Precautions

Using two alkali / carbon 1.5 volt battery;;
Suitable for 0-8 kg water pressure;
Suitable for water temperature of 0~ 40
You can set the specific water time and set the current specific time.
All-weatherproof. (it can be used outside)
there is a temporary watering function (no impact on the set of procedures)

how to use:
1. Turn the dial to set the appropriate program according to individual needs.

specification:
Color: as shown
Material: Material
size (L x W x H): 10x10x6.5 cm
Thread size: 2 cm
Outlet Screw Diameter: 2 cm, 1 cm
suitable water temperature: 0 to 40 degrees
degrees celsius Working pressure: 3-6 kg
Watering time: The minimum time for water is one minute, and the longest time is 300 minutes.
Power supply: 2x1.5 V, AA battery (Batteries are not included in the package)

Application range:
1. Wetting and rust removal
2. Air humidification
3. Chemical treatment
4. Chemical spraying
5. Liquid spraying
6. Tobacco leaf humidification
7. Tablet coating
8. Flue gas evaporative cooling
9. Disinfection
10. Unit cooling
11. Fruit wax spray
12. Ceramic tile glazing
13. Factory humidification
14. Salt fog test
15. Artificial fog
16. Humidification in other places

Notes:
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow 1-3cm measuring deviation due to manual measurement.

Effect and application

Advantages of misting kit

Easy installation in minutes; Affixed with saddle clamps or cable ties;
No power required, work with the pressure of facuet;3M water supply hose is available for the system;
All quick pushing connectors, easy for DIY; Fine fog mist, cool your summer heat immediately;

Instruction:

1. Connect the Facuet adapter to the water tap.
2. Turn on the water tap to wash the system for 1 minute to purge the system and remove any impurities.
3. Screw the misting nozzles to the Tee fittings, except the last one on the end plug.
4. Turn on the water tap to wash the system for 2 minute to insure that system is fully purged.
5. Turn the watet off and install the last nozzle into the fitting with the end plug.
6. Fix the misting line by the saddle clamps provided.
7. Turn on the tap slightly until jets are working, enjoy the cooling misting system.
8. Periodically remove the misting nozzles, and follow steps 2-5 to clean out the misting system.

Certification